Table Of Contents

Supported MIBs

MIB List

Using FTP to Access the MIB Files

Supported MIBs

---

This appendix lists the Simple Network Management Protocol (SNMP) Management Information Bases (MIBs) that the access point/bridge supports for this software release. The Cisco IOS SNMP agent supports both SNMPv1 and SNMPv2. This appendix contains these sections:

•MIB List

•Using FTP to Access the MIB Files

MIB List

•IEEE802dot11-MIB

•Q-BRIDGE-MIB

•P-BRIDGE-MIB

•CISCO-DOT11-IF-MIB

•CISCO-WLAN-VLAN-MIB

•CISCO-IETF-DOT11-QOS-MIB

•CISCO-IETF-DOT11-QOS-EXT-MIB

•CISCO-DOT11-ASSOCIATION-MIB

•CISCO-L2-DEV-MONITORING-MIB

•CISCO-DDP-IAPP-MIB

•CISCO-IP-PROTOCOL-FILTER-MIB

•CISCO-SYSLOG-EVENT-EXT-MIB

•CISCO-TBRIDGE-DEV-IF-MIB

•BRIDGE-MIB

•CISCO-CDP-MIB

•CISCO-CONFIG-COPY-MIB

•CISCO-CONFIG-MAN-MIB

•CISCO-FLASH-MIB

•CISCO-IMAGE-MIB

•CISCO-MEMORY-POOL-MIB

•CISCO-PROCESS-MIB

•CISCO-PRODUCTS-MIB

•CISCO-SMI-MIB

•CISCO-TC-MIB

•CISCO-SYSLOG-MIB

•ENTITY-MIB

•IF-MIB

•OLD-CISCO-CHASSIS-MIB

•OLD-CISCO-SYS-MIB

•OLD-CISCO-SYSTEM-MIB

•OLD-CISCO-TS-MIB

•RFC1213-MIB

•RFC1398-MIB

•SNMPv2-MIB

•SNMPv2-SMI

•SNMPv2-TC

Using FTP to Access the MIB Files

Follow these steps to obtain each MIB file by using FTP:

---

Step 1 Use FTP to access the server ftp.cisco.com.

Step 2 Log in with the username anonymous.

Step 3 Enter your e-mail username when prompted for the password.

Step 4 At the ftp> prompt, change directories to /pub/mibs/v1 or /pub/mibs/v2.

Step 5 Use the get MIB_filename command to obtain a copy of the MIB file.

---

---

Note You can also access information about MIBs on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

---