Document ID: 55518
Updated: Nov 12, 2006
Contents
Introduction
This document provides the sets of platforms, interfaces, and related Cisco IOS® Software Releases that support Block Serial Tunnel (BSTUN), binary synchronous communication (BSC), and Binary Synchronous Communication Protocol (Bisync).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Hardware Support Table
| Cisco Platform | Interface (if applicable) | Cisco IOS Software Support |
|---|---|---|
| 1720 | 12.0(2)T | |
| 2500 | 10.3 | |
| 2600 | WIC-1T WIC-2T WIC-2AS NM-4AS NM-8AS | 11.3(2)XA 11.3(3)T |
| 3600 | 11.1(7)AA 11.2(5)P | |
| 3810 | 12.0.2aT1 | |
| 4000 4500 4700 | NP4T | 10.3 |
| NP-2T16S-RS232 NP-2T16S-V.35 | 11.2(3)P | |
| 7200 | PA-4T+ PA-8T | 11.2(7)P |
| 1600 | 11.2(6.4)P | |
Note: The PA-4T does not support BSC; you must have a PA-4T+. There is no upgrade path from the PA-4T to the PA-4T+.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.