Setting the SPA3102 to Bridge Mode [Cisco Small Business Voice Gateways and ATAs]

Document ID: 108733

Updated: Dec 12, 2008

Introduction
How to set the SPA3102 to bridge mode?
Related Information

Introduction

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How to set the SPA3102 to bridge mode?

There are two ways to set the device to Bridge Mode:

Set the SPA3102 to Bridge Mode using the IVR
Setthe SPA3102 to Bridge Mode using the web-based setup page

Set the SPA3102 to Bridge Mode using the IVR
In order to set the SPA3102 to Bridge Mode using the IVR, dial **** 201. The user will now be able to press 1 in order to enable or 0 to disable the device's router functionality.

Set the SPA3102 to Bridge Mode using the web-based setup page
In order to set the SPA3102 to Bridge Mode using the web-based setup page, complete these steps:

Step 1:
Access the SPA3102's web-based setup page. For instructions click here.

Step 2:
When the SPA3102's web-based setup page appears, click advanced and then Lan Setup.

Step 3:
Under Networking Service, select Bridge from the drop-down menu.

Step 4:

Click .