Document ID: 108726
Updated: Dec 12, 2008
Contents
Introduction
What can I do to enable the SPA3000 Auto PSTN Fallback?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. What can I do to enable the SPA3000 Auto PSTN Fallback?
A.The SPA3000 Auto PSTN Fallback works when it is set to yes. You should be able to dial local numbers when you have the device powered off (power failure or physically off) without dialing a prefix number 9 as shown on the dial plan.
Step 1:
Access the SPA3000's web-based setup page. For instructions, click here.Step 2:
Click Admin Login then advanced.
Step 3:
Click Line 1 and look for VoIP Fallback To PSTN and set Auto PSTN Fallback to yes.
Step 4:
Click
.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.