FeedbackTable Of Contents
Cisco 7600, CRS-1, and 4948 Devices
Trap Definitions
The Cisco Video Assurance Management Solution (Cisco VAMS) supports traps (alarms) for:
•
Cisco 7600, CRS-1, and 4948 Devices
Cisco Multicast Manager
The Layer 3 multicast bandwidth percentage on an interface has exceeded the percentage threshold.
Minor
The designated router for an interface has been detected.
Warning
One or more parameters of a multicast route entry has changed.
Warning
The rendezvous point did not respond to a sysUpTime poll.
Information
The Layer 3 multicast b/s rate for a (source,group) has exceeded the high b/s rate threshold.
Minor
The application has rediscovered a router.
Information
The rendezvous point responded to a sysUpTime poll.
Information
The designated router for an interface has been removed.
Major
That a health check has detected one or more failures.
Minor
The Layer 3 multicast bandwidth percentage on an interface has exceeded the percentage threshold.
Information
The Layer 3 multicast Reverse Path Forwarding (RPF) failures for a (source, group) that is now being measured at a value above the low threshold.
Minor
The unicast or multicast routing table has changed compared to the initial baseline.
Information
The video probe media loss rate (MLR) for a video flow has exceeded the configured threshold.
Major
The multicast group limit exceeded the configured threshold on the rendezvous point.
Minor
A Layer 2 port multicast p/s low threshold is exceeded.
Minor
The Layer 3 multicast b/s rate for a (source, group) has exceeded the low b/s rate threshold.
Minor
A rendezvous point that did not respond to a poll.
Information
The Layer 3 multicast p/s rate for a (source, group) has exceeded the set threshold when measured between the routers on a multicast forwarding tree.
Warning
A (source, group) no longer exists on the router.
Major
One or more parameters of a unicast route entry has changed.
Information
A multicast forwarding tree that has reverted to its baseline.
Warning
The Layer 3 multicast b/s rate for a (source, group) has exceeded the high b/s rate threshold.
Cleared
The multicast p/s rate for the aggregate multicast traffic on a Layer 2 port, which is now being measured at a value between the high and low p/s rate thresholds.
Cleared
A (source, group) has been removed from the rendezvous point since the poll.
Major
Notification that the video probe delay factor (DF) for a video flow has exceeded the configured threshold.
Major
A (source, group) has been added to the rendezvous point since the last poll.
Information
A Layer 2 port multicast p/s high threshold is exceeded.
Minor
The multicast bandwidth percentage for the aggregate multicast traffic on an interface is now at a value lower than the high threshold.
Cleared
The Layer 3 multicast p/s rate for a (source, group) that is now being measured at a value between the high and low p/s rate thresholds.
Cleared
A multicast group that has more than a single source sending to it.
Major
A multicast forwarding tree that has changed from its baseline.
Warning
The Layer 3 multicast p/s rate for a (source, group) has exceeded the high p/s rate threshold.
Minor
The Layer 3 multicast p/s rate for a (source, group) has exceeded the low p/s rate threshold.
Minor
The designated router for an interface has changed.
Warning
A multicast sender on the default multicast distribution tree (MDT) for a particular VPN routing/forwarding (VRF) instance has been removed.
Warning
A VRF on a multicast VPN (MVPN) Provider Edge (PE) router has been removed.
Warning
A default MDT address for a VRF has been configured on a PE that does not match the configuration on the rest of the PEs.
Warning
The number interfaces associated with a VRF on an MVPN PE has changed.
Warning
A VRF on an MVPN PE has been added.
Warning
A new multicast sender on the default MDT for a particular VRF has been detected.
Warning
The number of VRFs configured on an MVPN PE has changed.
Warning
1 See Glossary for abbreviations that are used in alarm message text.
Textronix Video Probe
Number of packet received out of order exceeds Warning threshold
Warning
Inter packet delay exceeds Warning threshold
Warning
IP Packets lost exceeds Warning threshold
Warning
IP Packets in error exceeds Warning threshold
Warning
Number of packet received out of order exceeds threshold
Minor
IP Packets lost exceeds threshold
Minor
IP Packets in error exceed threshold
Minor
1.5a PMT
Major
2.5 PTS
Minor
1.5 Ind PMT Error Timer
Major
2.3b PCR Discontinuity Indicator - The difference between two consecutive PCR values (PCRi + 1 - PCRi) is outside the range of 0ms to 100 ms without the discontinuity_indicator set
Minor
2.3a PCR Repetition - Error Timer
Minor
1.4 Continuity
Major
2.3b PCR Discontinuity Indicator - This test applies only to PIDs that are indicated as PCR_PID in the current PMT
Minor
2.3a PCR EVID_INDIVIDUAL_PCR_ERR_TIMER
Minor
1.5 PMT Error Scrambling
Major
1.5 PMT Error Timer
Major
1.3 PAT Error Scrambling
Major
1.3 PAT Error Table Id
Major
1.3 PAT Error Timer
Major
2.4 PCR Accuracy
Minor
CAT (DVB test 2.6)
Minor
PTS (DVB test 2.5)
Minor
PCR Accuracy (DVB test 2.4)
Minor
CRC (DVB test 2.2)
Minor
Transport (DVB test 2.1)
Minor
PMT (DVB test 1.5)
Major
PAT Table (DVB test 1.3)
Major
1.6 PID
Major
PID (DVB test 1.6)
Major
Continuity Error (DVB test 1.4)
Major
Sync Byte (DVB test 1.2)
Major
Sync Loss (DVB test 1.1)
Major
1 See Glossary for abbreviations that are used in alarm message text.
IneoQuest Video Probe
The network utilization on the primary port exceeds the threshold value.
Minor
User feedback event.
Information
The delay factor threshold crossover is detected.
Minor
A stream was lost for a period defined in the outage.
Major
A 15-minute monitored metric threshold crossover is detected.
Information
The Bit-Rate for a stream exceeds the threshold value.
Warning
The maximum RTP media loss period threshold crossover is detected.
Minor
A system fault condition occurred.
Minor
Software or config download.
Information
This trap is sent when link is lost.
Major
This event is sent every 15-Min to indicate the completion of an interval of system statistics.
Information
The PID bitrate threshold is crossed for a PID selected from the video characteristic template.
Minor
This trap is sent when the media loss threshold crossover is detected.
Minor
The minimum loss distance threshold crossover is detected.
Minor
The media loss threshold crossover is detected.
Minor
The multicast IGMP join time threshold crossover is detected.
Information
The stream alarms limit is reached for a 15-Minute period.
Information
The media link is established.
Information
A new flow has been detected by the system.
Information
The bit rate for a stream exceeds the threshold value.
Minor
A stream was lost for a period defined in the outage.
Major
The Minimum Bit-Rate Threshold is crossed.
Warning
The ZAP time threshold crossover is detected.
Information
1 See Glossary for abbreviations that are used in alarm message text.
Mixed Signals Video Probe
Table bit rate
Warning
Table detect
Warning
Table cycle time
Warning
PID bit rate
Warning
PID detect
Warning
PID discontinuity
Minor
PID audio silence
Minor
PID video freeze
Minor
PID table bit rate
Warning
PID table detect
Warning
PID table cycle time
Warning
Program bit rate
Warning
Program detect
Warning
Program discontinuity
Warning
Program audio silence
Warning
Program video freeze
Warning
Program PCR interval
Warning
Program PCR jitter
Warning
Program table PMT bit rate
Warning
Program table PMT detect
Warning
Program table PMT cycle time
Warning
DSM-CC DII bit rate
Warning
DSM-CC DII detect
Warning
DSM-CC DII cycle time
Warning
DSM-CC DC bit rate
Warning
DSM-CC DC detect
Warning
DSM-CC DC cycle time
Warning
Carousel bit rate
Warning
Carousel source file add-delete
Warning
Carousel source DSM-CC DII bit rate
Warning
Carousel source DSM-CC DII detect
Warning
Carousel source DSM-CC DII cycle time
Warning
Carousel source DSM-CC DC bit rate
Warning
Carousel source DSM-CC DC detect
Warning
Carousel source DSM-CC DC cycle time
Warning
Carousel file bit rate
Warning
Carousel file detect
Warning
Carousel file cycle time
Warning
Carousel file change
Warning
Port IP arrival interval
Warning
Port delay factor
Warning
1 See Glossary for abbreviations that are used in alarm message text.
Cisco 7600, CRS-1, and 4948 Devices
PIM Neighbor loss
Major
PIM Interface down
Major
PIM Interface up
Clear
The number of multicast routes changed.
Information
The number of non-RPF drops exceeded threshold.
Minor
1 See Glossary for abbreviations that are used in alarm message text.
Performance Metrics
For the Cisco VAMS, the Cisco ANA supports a:
•
•
Cisco ANA drops traps that exceed the cut-off rate. For example, if a VNE receives six traps per second, the ANA drops the sixth trap. Also, the cut-off rate is cumulative. For example, for two VNEs, the cut-off rate is 10 traps per second.