Feedback
Contents
W
watcher all
To allow an external watcher to monitor an internal presentity, use the watcher allcommand in presence configuration mode. To disable monitoring by external watchers, use the no form of this command.
Usage Guidelines
This command allows external watchers on a remote router connected through a SIP trunk to monitor internal directory numbers. You must enable the allow watch command on the internal directory numbers that are watched. To allow external watching from the remote router, you must enable the allow subscribe command on the remote router.
Examples
The following example shows how to enable external watching of an internal presentity:
Router(config)# presence Router(config-presence)# watcher allRelated Commands
Command
Description
allow subscribe
Allows internal watchers to monitor external presentities.
allow watch
Allows a directory number on a phone registered to Cisco Unified CME to be watched in a presence service.
presence
Enables presence service on the router and enters presence configuration mode.
presence enable
Allows incoming presence requests from SIP trunks.
server
Specifies the IP address of a presence server for sending presence requests from internal watchers to external presence entities.
show presence global
Displays configuration information about the presence service.
show presence subscription
Displays information about active presence subscriptions.
xsvc
To add support for extended serviceability (xsvc) on TDM, (ISDN-PRI/BRI, DS0-group, analog voice-port) voice interfaces, which are defined as a trunk group, use thexsvc command. To disable support for extended serviceability, use theno form of this command.
Usage Guidelines
Use this command to add support for extended serviceability on voice interfaces which are defined as a trunk group.