Document ID: 14162
Updated: Sep 09, 2005
Contents
Introduction
This document provides a troubleshooting flowchart for the Hard Plug Loopback test for E1 lines. To see more infomation on the commands below, refer to Hard Plug Loopback Tests for E1 Lines.
Prerequisites
Requirements
There are no specific prerequisites for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
Troubleshooting Flowchart
Related Information
- E1 Troubleshooting
- E1 Layer 1 Troubleshooting
- E1 Alarm Troubleshooting
- E1 Error Event Troubleshooting
- E1 PRI Troubleshooting
- Access Technology Support Pages
- Technical Support - Cisco Systems
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.
Updated: Sep 09, 2005
Document ID: 14162