Document ID: 26888
Updated: Oct 20, 2006
Contents
Introduction
This document provides functionality information for the NM-16ESW and NM 36ESW network modules.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Configure
Transparent bridging support on the NM-16ESW or NM 36ESW modules was added in Cisco IOS® Software Releases 12.2(15)ZJ and 12.3(4)T. Prior to these releases, both transparent bridging and DLSw were not supported on these modules.
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.