Document ID: 71111
Updated: Sep 20, 2006
Contents
Introduction
This document discusses the Point-to-Point Protocol over ATM (PPPoA) implementation options.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Options
Select one of these PPPoA implementation options for your Asymmetric Digital Subscriber Line (ADSL) service. Both implementation options include configuration examples for Network Address Translation (NAT) overload, NAT Pool, Static NAT, and Dynamic Host Control Protocol (DHCP) Server.
Select the option that describes the type of PPPoA service your ISP provides.
-
PPPoA Option 1—Your ISP assigns a single dynamic public IP address to your Cisco DSL Router.
-
PPPoA Option 2—Your ISP assigns a single static public IP address to your Cisco DSL Router.
Return to the Main Page of this configuration guide.
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.