Document ID: 8635
Updated: Feb 02, 2006
Contents
Introduction
This document describes the E&M Cable Pinouts connecting a Cisco 1750/2600/3600 E&M voice interface card (VIC) to a Lucent PBX G3R E&M Trunk.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
Pinout
Note: Lucent G3R PBX ty1-stan and ty5 interoperate with Cisco 1750/2600/3600 E&M VIC.
Type 1 & 5; 4-wires; router to PBX -----Lucent-----
Router Pins PBX
1 --
M 2 -- 6 M
R 3 -- 4 TA
R1 4 -- 1 RA
T1 5 -- 2 RB
T 6 -- 5 TB
E 7 -- 3 E
8 --
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.