Document ID: 109038
Updated: Dec 12, 2008
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. How can I use NSLOOKUP to see my MX records for ProtectLink Gateway Email Protection?
A.To retrieve the MX records using NSLOOKUP, please perform the following:
Step 1:
Open a command prompt.
Step 2:
Type "nslookup" and press Enter. You will see the following:
Default Server: <FQDN of your server>
Address: <server IP address>
Step 3:
Type "set type=mx" and press Enter.
Step 4:
Type the domain name that you want to look up and press Enter. The MX records of that domain will show up.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.