Document ID: 108925
Updated: Dec 12, 2008
Contents
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Q. Where can I find the mail exchange (MX) records to use for ProtectLink Gateway Email Protection?
A. You must redirect MX records to point to the ProtectLink Gateway Email Protection servers in order for emails to be filtered.
After ProtectLink Gateway is registered, you receive a welcome email that contains information on which MX records to use and the result of the test email.
Do not change the MX records until you receive the test email. If you do not receive the welcome or the test email, send an email to imhs_support@trendmicro.com.
Note: When you modify MX records, the full transition (DNS propagation) can take up to 48 hours. Do not discontinue any on-premise security during this time. You can still receive some email directly until the transition period completes.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.