
Document ID: 116518
Updated: Oct 01, 2013
Contributed by Scott Hills, Cisco TAC Engineer.
Contents
Introduction
This document describes a problem encountered when you attempt to control a DeskPhone from Cisco Jabber and presents one possible solution to the problem.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
- Cisco Jabber Version 9.2.x
- Cisco CallManager Version 9.1.x
- Cisco Unified Presence Server (CUPS) Version 9.1.x
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Problem
You are unable to control your DeskPhone via Cisco Jabber, and a red X appears at the bottom of the Jabber console window. When you navigate to Help > Show Connection Status from your Jabber console, you might see this report:
Deskphone
Status: Not connected
Reason: Connection error: Ensure the server information in the Phone Services tab
on the Options window is correct. Contact your system administrator for assistance.
Solution
Complete these steps in order to resolve this problem:
- Ensure that your Jabber-enabled PC is able to download a file from the TFTP server (Callmanager).
- Enter the Tftp -i <cucm ip address> get <SEP>.cnf.xml command from your PC in order to download the TFTP file. In this instance, the name of the phone device is SEP, which is the MAC address.
- If the file does not download, ensure that Windows Firewall or Physical Firewall do not block your access to port 69 or the Jabber application access. In order to ensure this, navigate to Control Panel > Windows Firewall > Allow a program or feature through Windows Firewall, and check the Cisco Jabber check box.
- If the previous steps do not resolve this issue, log in to CUPS and navigate to Application > Legacy Clients > Primary TFTP. You must populate the TFTP address for the Primary (at a minimum).
Troubleshoot
In order to troubleshoot this problem further, complete these steps:
- Gather a Problem Report from Jabber. Navigate to Help > Report a problem, and follow the prompts given via the wizard.
- Review the cfs-unified.log that contains the time-frame, or a reproduction of the problem.
- In the log, search for a line that looks similar to this:
2013-09-06 10:47:12,139 ERROR[0x0000115c][control\CallControlManagerImpl.cpp(1384)]
[csf.ecc][ecc::CallControlManagerImpl::doConnect]- doConnect() failed - No local
IP address set! : eNoLocalIpConfigured
Related Information
Open a Support Case (Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.