Cisco Nexus 2000 Series Fabric Extenders

Introduction

This document describes failure messages and general troubleshooting procedures for the Cisco Fabric Extender (FEX) power supply.

Continuous Messages for GPIO Access Failure

In this example, the logs reveal continuous messages for general purpose input/output (GPIO) access failure:

%SATCTRL-FEX133-2-SOHMS_DIAG_ERROR: FEX-133 Module 1: Runtime diag 
detected major event: GPIO access failure
%SATCTRL-FEX133-4-SOHMS_PS_GPIO: FEX-133 System PS access failure 
on Power supply: 1
%SATCTRL-FEX133-4-SOHMS_PS_GPIO: FEX-133 System PS access failure 
on Power supply: 2

The appropriate solution depends upon the software version on the Nexus 5000 or Nexus 7000.

Nexus 5000 and NX-OS Version Earlier than 5.0(3)N2(1)

This is a known cosmetic issue; see Cisco bug ID CSCtl77867 (FEX PS runtime diag detected major event: GPIO access failure). The solution is to reload the FEX or upgrade to version 5.0(3)N2(1) or later.

Nexus 5000 and NX-OS Version 5.0(3)N2(1) or Later

See Cisco bug ID CSCtz84683 (continuous GPIO access failure message seen on FEX).

Note: Only FEX power supplies with serial numbers that start with DTN are affected; power supplies with serial numbers that start with LIN are not affected.

Nexus 7000

See Cisco bug ID CSCtr77620 (FEX: System minor alarm on power supply 1 & Recovered).

Other Failure Messages for FEX Power Supply

This example shows other failure messages for the FEX power supply:

%SATCTRL-FEX104-2-SOHMS_DIAG_ERROR: FEX-104 Module 1: Runtime diag detected major event:
Voltage failure on power supply: 1
%SATCTRL-FEX104-2-SOHMS_DIAG_ERROR: FEX-104 System minor alarm on power supply 1: failed
%SATCTRL-FEX104-2-SOHMS_DIAG_ERROR: FEX-104 Recovered: System minor alarm on power 
supply 1: failed

Methods to resolve these issues include:

1. Reseat the FEX power supply; use the redundant power supply to ensure the power does not go offline.
2. Submit a Return Material Authorization (RMA) for the FEX power supply; use the redundant power supply to ensure the power does not go offline.
3. Repeat these steps for the second power supply.

Troubleshooting

The first step in troubleshooting is to check for hardware and power issues. If you have a software issue, error messages continue even after you swap hardware.

Review and answer these questions in order to help define the circumstances of the failure:

1. How many FEX power supplies are affected ?
2. For a minor alarm, did you swap the input source, and did that make any difference?
3. Do you have other FEX power supplies that are having issues?
4. Do you have any other boxes of the same power source?
5. Did you replace the power cord?
6. Was there a power surge or glitch in the environment?

Gather output from these commands in order to investigate the failures:

• show sprom fex 100 all
• show logging log | no-more
• show tech fex 100 | no-more
• attach fex 100
• show platform software satctrl trace

Note: Use the Command Lookup Tool (registered customers only) in order to obtain more information on the commands used in this section.

Related Information

• Technical Support & Documentation - Cisco Systems