Document ID: 109248
Updated: Dec 12, 2008
Contents
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. Why is the power light of my WPC4400N not lighting up?
A.
The power light of the WPC4400N indicates that the device is active. If the power light is not lit it means that the laptop did not recognize the adapter. Listed below are some steps on troubleshooting the adapter with the power not lighting up:
- Make sure that the WPC4400N is properly seated on the PCMCIA slot of the laptop.
- Install the card on a different laptop if possible.
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.
Updated: Dec 12, 2008
Document ID: 109248