Document ID: 108714
Updated: Dec 12, 2008
Contents
Introduction
What can I do if I encounter bad audio quality when I use the CIT200?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. What can I do if I encounter bad audio quality when I use the CIT200?
A.Bad audio quality from the CIT200 can be attributed to signal interference caused by nearby electrical appliances such as microwave ovens and cordless phones or the Base Station is installed in a room with thick walls. If this is the case, move the computer to a different location. It can also be that the handset may be too far from the base unit. If so, move the Handset closer to the Base Station.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.