Table Of Contents

Configuring MIB2 System Group in Cisco Unified Serviceability

Configuring the MIB2 System Group

Configuring MIB2 System Group in Cisco Unified Serviceability

---

Cisco  Unified Serviceability allows you to configure the system contact and system location objects for the MIB-II system group. For example, you could enter Administrator, 555-121-6633, for the system contact and San Jose, Bldg 23, Second floor, for the system location.

•Configuring the MIB2 System Group

Configuring the MIB2 System Group

You can configure a system contact and system location for the MIB-II system group.

---

Tip This procedure supports SNMP v1, v2c, and v3 configuration.

---

Procedure

---

Step 1 Select Snmp > SystemGroup > MIB2 System Group.

Step 2 Configure the MIB2 System Group settings, as described in the table below.

Table 9-1 MIB2 System Group Configuration Settings 

Field	Description
Server	a. Select the server for which you want to configure contacts from the list box. b. Select Go.
System Contact	Enter a person to notify when problems occur.
System Location	Enter the location of the person that is identified as the system contact.
Apply To All Nodes	Check to apply the system configuration to all of the nodes in the cluster.

Step 3 Select Save. A message indicates that changes will not take effect until you restart the SNMP master agent.

Step 4 Perform one of the following actions:

a. Select OK to restart the SNMP master agent service.

b. Select Cancel to continue the configuration without restarting the SNMP master agent.

Step 5 Perform one of the following actions:

a. Select Clear All to clear the System Contact and System Location fields.

b. Select Clear All and Save to delete the system configuration.

---