 Feedback
|
Table Of Contents
Cisco Unified SIP Phone 3951
Release Notes for Firmware Release 8.0Supported CallManager Versions
Cisco Unified CallManager Device Packs
Obtaining Documentation, Obtaining Support, and Security Guidelines
Cisco Unified SIP Phone 3951
Release Notes for Firmware Release 8.0
February 28, 2007Use these release notes with the firmware release 8.0 for the Cisco Unified SIP Phone 3951, which is available only in Asia Pacific and Latin American countries.
This SIP version of firmware release 8.0 is compatible with Cisco Unified CallManager release 5.1 or later.
Contents
These release notes provide the following information:
•
Obtaining Documentation, Obtaining Support, and Security Guidelines
Related Documentation
Cisco Unified IP Phone Documentation
Refer to publications that are specific to your language, phone model and Cisco Unified CallManager release. Navigate from the following documentation URL:
http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/index.htm
Cisco Unified CallManager Documentation
Refer to the Cisco Unified CallManager Documentation Guide and other publications specific to your Cisco Unified CallManager release. Navigate from the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/voice/c_callmg/index.htm
New and Changed Information
The Cisco Unified SIP Phone 3951 is a cost-effective entry-level phone for use in a lobby, laboratory, manufacturing floor, or hallway. This phone belongs to the family of Cisco Unified IP Phones, running Session Initiation Protocol (SIP) on Cisco Unified CallManager but differs from other Cisco Unified Phones as follows:
•
•
•
•
•
For more information, see the Cisco Unified SIP Phone 3951 Administration Guide for Cisco Unified CallManager 5.1.
Installation Notes
The following sections provide firmware information and supported Cisco Unified CallManager versions:
•
Firmware Information
You must download these firmware and the Readme files that contain installation instructions for the Cisco Unified SIP Phone 3951:
•
•
You can download these files from this location on Cisco.com:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-3900ser
Supported CallManager Versions
This Cisco Unified SIP Phone 3951 firmware release is supported with Cisco Unified CallManager version 5.1 or later.
Cisco Unified CallManager Device Packs
You should install this device pack for Cisco Unified CallManager:
DPInstall5_1_1_2104-1
You can download the device pack from this location on Cisco.com:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-3900ser
Caveats
This section contains these topics:
Using Bug Toolkit
Known problems (bugs) are graded according to severity level. These release notes contain descriptions of:
•
•
You can search for problems by using the Cisco Software Bug Toolkit.
To access Bug Toolkit, you need the following items:
•
•
•
To use the Software Bug Toolkit, follow these steps:
Procedure
Step 1
Step 2
Step 3
Step 4
Open Caveats
Table 1 lists Severity 1, 2 and 3 defects that are open for Cisco Unified SIP Phone 3951 using firmware release 8.0.
For more information about an individual defect, you can access the online record for the defect by clicking the Identifier or going to the URL shown. You must be a registered Cisco.com user to access this online information.
Because defect status continually changes, be aware that Table 1 reflects a snapshot of the defects that were open at the time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in the "Using Bug Toolkit" section.
Table 1 Open Caveats for Cisco Unified SIP Phone 3951 for Firmware Release 8.0
Cisco Unified SIP Phone 3951 rejects Cisco Discovery Protocol (CDP) from some switches
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsf32575
The first few milliseconds of autoattendant is not audible
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsg12598
Cisco Unified SIP Phone 3951 echo loss is less than the requirement
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsg14533
After the Cisco Unified SIP Phone 3951 performs an attended transfer, the phone rings once and displays hour glass icon
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsg20223
Cisco Unified SIP Phone 3951 displays anonymous caller ID for redirect call flow in Cisco Unified Survivable Remote Site Telephony (SRST) mode
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsg59003
Dual-Tone Multifrequency (DTMF) tones should not be heard on speakerphone
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsg69013
Cisco Unified SIP Phone 3951 Music On Hold (MOH) is heard when on hold during a conference
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsh24304
Display error after connecting a party in a three-way conference
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsh27324
Phone features are allowed on held calls
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsh27330
Resolved Caveats
There are no resolved caveats for Cisco Unified SIP Phone 3951 for firmware release 8.0.
Obtaining Documentation, Obtaining Support, and Security Guidelines
For information on obtaining documentation, obtaining support, providing documentation feedback, security guidelines, and also recommended aliases and general Cisco documents, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
.
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2007 Cisco Systems, Inc. All rights reserved.
