Cisco TelePresence Server

Why can't I start a presentation in a conference on the TelePresence Server while another presentation is being shown?

If you are using a TelePresence Server running software version 1.0, starting to contribute content is only allowed if there is no existing presentation in the conference: you must wait until the current presentation stops. However, for software version 1.1 and above, you can allow a presentation to start while another is being shown, which stops the original presentation:

1. Log into the TelePresence Server, go to Configuration > System settings.
2. Locate and check the Automatic content handover checkbox.
3. Click Apply Changes.

This article applies to the following products:

• Cisco TelePresence Servers