 Feedback
|
Which gatekeepers have been tested for the Cisco TelePresence IP VCR?
The table below shows the gatekeepers (and versions) that have been tested with the IP VCR for calls. The latest verisons of each gatekeeper support neighboring with the IP VCR's built-in gatekeeper.
We recommend that you use the Terminal / Gateway setting unless you are using a service prefix or point-to-point prefix (in this case, use Gateway). Only use a different option if you are:
- using the Cisco Gatekeeper (with or without a service prefix), in which case use Gateway (Cisco GK Compatible)
- using the VCON MXM Gatekeeper (with or without a service prefix), in which case use Gateway
| Gatekeeper | Version | Routed mode | Recommended registration type: |
|---|---|---|---|
| Cisco VCS | X3.x X4.x |
H.245-routed |
Terminal/Gateway - if you do not use a service prefix |
| Cisco acquired TANDBERG Gatekeeper | N4.0 N5.x N6.x |
Direct |
Terminal/Gateway - if you do not use a service prefix |
| H.245-routed (indirect routed) | |||
| Cisco acquired TANDBERG Codian | 2.0(x) and later | Direct |
Terminal/Gateway - if you do not use a service prefix |
| GNUGK | 2.2.3-2 | Direct |
Terminal/Gateway - if you do not use a service prefix |
| Polycom PathNavigator | 7.00.00 | Direct |
Terminal/Gateway - if you do not use a service prefix |
| H.245-routed (indirect routed) | |||
| Polycom V2IU | 6.1.2 | Direct |
Terminal/Gateway - if you do not use a service prefix |
| Radvision ECS | 4.0.x | Direct |
Terminal/Gateway - if you do not use a service prefix |
| H.225-routed (Radvision refer to this mode as Q.931-routed) | |||
| H.225-routed (Q931-routed) / H.245-routed (also known as indirect routed) | |||
| Emblaze-Vcon MXM Gatekeeper | 4.14 | Routed | Gateway |
| Cisco Gatekeeper | 12.3(19) | Direct | Gateway (Cisco GK Compatible) |
This article applies to the following products:
- Cisco TelePresence IP VCR 2200 / MSE VCR blade
| June 22nd, 2011 | TAA_KB_19 |