Table Of Contents

F Commands

feature vrrp

F Commands

---

This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with F.

feature vrrp

To enable the Virtual Router Redundancy Protocol (VRRP), use the feature vrrp command. To disable VRRP, use the no form of this command.

feature vrrp

no feature vrrp

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

Global configuration mode

Command History

Release	Modified
5.2(1)N1(1)	This command was introduced.

Usage Guidelines

You must enable the VRRP feature before you can configure VRRP.

---

Note In Cisco NX-OS Release 5.2(1)N1(1), a software upgrade on the Cisco Nexus 5548 switch and the Cisco Nexus 5596 switch that has the Layer 3 features enabled is disruptive. You must reload the switch and the Cisco Nexus 2000 Series Fabric Extender.

---

This command does not require a license.

---

Note Make sure the LAN Base Services license is installed on the switch to enable Layer 3 interfaces.

---

Examples

This example shows how to enable the VRRP feature:

switch# configure terminal

switch(config)# feature vrrp 

switch(config)# 

This example shows how to disable the VRRP feature:

switch# configure terminal

switch(config)# no feature vrrp 

switch(config)# 

Related Commands

Command	Description
clear vrrp	Clears all the software counters for the specified virtual router.
show feature	Displays the status of features on a switch.
show vrrp	Displays VRRP configuration information.
vrrp	Configures a VRRP group on an interface.