Table Of Contents

M Commands

management

M Commands

---

This chapter describes the Cisco NX-OS interface commands that begin with M.

management

To configure a switch virtual interface (SVI) that should be used for in-band management, use the management command. To remove the in-band management access to a VLAN interface IP address, use the no form of this command.

management

no management

Syntax Description

This command has no arguments or keywords.

Command Default

None

Command Modes

Interface configuration mode
Switch profile configuration mode

Command History

Release	Modification
5.2(1)N1(1)	This command was introduced.

Usage Guidelines

You can use this command on a VLAN interface.

Examples

This example shows how to configure a VLAN interface to allow in-band management access:

switch# configure terminal

switch(config)# interface vlan 5

switch(config-if)# management

switch(config-if)#

This example shows how to remove the in-band management access to a VLAN interface:

switch# configure terminal

switch(config)# interface vlan 5

switch(config-if)# no management

switch(config-if)#

Related Commands

Command	Description
show running-config interface	Displays the running configuration information for an interface.