Guest

Cisco IOS Software Releases 12.2 SR

ISSU - GLBP

Downloads

 Feedback

Table Of Contents

ISSU—GLBP

Configuration Information

Master Commands Lists


ISSU—GLBP


GLBP supports In Service Software Upgrade (ISSU). ISSU allows a high-availability (HA) system to run in Stateful Switchover (SSO) mode even when different versions of Cisco IOS software are running on the active and standby Route Processors (RPs) or line cards.

ISSU allows a high-availability (HA) system to run in Stateful Switchover (SSO) mode even when different versions of Cisco IOS software are running on the active and standby Route Processors (RPs). This feature allows the system to switch over to a secondary RP running upgraded (or downgraded) software and continue forwarding packets without session loss and with minimal or no packet loss.

This feature is enabled by default.

Configuration Information

Configuration information is included in the Cisco IOS In Service Software Upgrade Process document at:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122sr/newft/122srb33/sbisefsu.htm

For detailed information about ISSU on the 7600 series routers, see the ISSU and eFSU on Cisco 7600 Series Routers document at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/software/122sr/swcg/efsuovrw.htm

Master Commands Lists

Cisco IOS master commands lists provide an alphabetical list of all Cisco IOS commands in a Cisco IOS release.

Cisco IOS new, modified, removed, and replaced commands lists provide an alphabetized list of all new, modified, removed, and replaced commands in a Cisco IOS release.

Release 12.2SB

Cisco IOS Master Commands List, Release 12.2SB, at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122sb/122sbrln/122sbix.htm

Release 12.2SR

Cisco IOS Master Commands List, Release 12.2SR, at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122sr/122srmdx/122sridx.htm


Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.

© 2007 Cisco Systems, Inc. All rights reserved.