 Feedback
|
Table Of Contents
BGP Support for Next-Hop Address Tracking
BGP Support for Next-Hop Address Tracking
The BGP Support for Next-Hop Address Tracking feature is enabled by default when a supporting Cisco IOS software image is installed. BGP next-hop address tracking is event driven. BGP prefixes are automatically tracked as peering sessions are established. Next-hop changes are rapidly reported to the BGP routing process as they are updated in the Routing Information Base (RIB). This optimization improves overall BGP convergence by reducing the response time to next-hop changes for routes installed in the RIB. When a best path calculation is run in between BGP scanner cycles, only next-hop changes are tracked and processed.
Configuration Information
Configuration information is included in the "Configuring Advanced BGP Features" chapter of the Cisco IOS BGP Configuration Guide, Release 12.4T, at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcg/tbgp_c/brbadv.htm
Command Reference Information
Command reference information is included in the Cisco IOS IP Routing Protocols Command Reference, Release 12.2SR, at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122sr/cr/sripr_r/index.htm
New or Modified Commands
The following command is modified for this feature:
•
bgp nexthop
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2006 Cisco Systems, Inc. All rights reserved.